The task was to create a Blister using the given materials. The tear shaped form was fabricated through the use of a hammering tool. When creating the piece, I have used the process shown in the video that was given to us by Russell. Here is what i did!
- As always, aluminium sheets were cut to wanted size.
- A wooden piece was given to us with the tear shape branded which had to be cut down using an electrical jigsaw and a bobbin sander
- Using this cut wooden board, the aluminium sheet was placed on top, which was clamped together to all four corners.
- Utilising the round shape of the nylon mallet, it was placed onto the side and was hammered down using another nylon mallet (this description is pretty shit so I will upload a video demonstration later.
- The thick mallet wasn't able to shape the sharper edge of the tear shape, so a thinner and sharper wooden piece was used instead.
- After creating the shape, the same sharp wooden piece was used the hammer the edges of the Blister to highlight the shape
No comments:
Post a Comment